Chopped at last

Haven't had a good shed sesh in a few weeks, partly because I've been busy, and partly because I was avoiding chopping that fender! Well tonight I finally pulled my finger out and took some advice.

Marked it with tape and then took the angle grinder to it. Wanted to add some strength back into the fender to I bent a piece of 5mm bar by hand into the rough profile. I tacked it in place bit by bit to bend it to shape before fully welding it in

Cleaned it up with the flapper disc and tried it on the bike. Now I've done it I'm actually pleased with the result. It's clean and simple and necessary.